When encoder (vMix, OBS etc) connects to the server then Line shows “green”- icon and info about processing (this values updates every 3 seconds) :
The following information is displayed at the top:
- frame size and fps
- decoder type: SW means software , HW means hardware
- start and max buffer
- effective SRT latency
- IP address of encoder side (it will be 127.0.0.1 for proxy mode connection)
- uptime
The following information is displayed at the bottom:
- decoded fps – shows info about decoded fps. For good network it should be same as input fps. For unstable network this value will be jumped.
- a/v buffers – shows how many frames wait output in buffer. It depends on “Max.Delay” value.
- bitrate – shows info about input bitrate.
- loss – shows the number of lost packets
- drops – shows the number of dropped packets
Buttons:
Disconnect – use it for stop stream. After disconnect the server will ready accept new connection for this line.
Reset buffer – use if for drop all frames from buffer. It allows got real-time.
NDI OFF – use if for pause NDI processing.
R – start/stop recording (dumping)
